4 Easy Steps Watch Full Application
Our Application Step by Step
Step 1: Coat Segments
First, take the lashes out of the tray,
and apply the bonding agent to the top roots of all five segments. After applying the bond to every segment, place the segments back in the lash tray. (Remove sticker that holds lashes to the tray)
Step 2: Coat Your Lashes
Coat your lashes with the bonding agent, using the product generously and applying as if it were mascara. Apply 2 to 3 coats to have the perfect amount of bond on your natural lashes.
Step 3: Place Lash Segments
Start placing the lash segments underneath your natural eyelashes in a upward motion. When placing the segments, make sure you apply them parallel to your natural lashes to be placed properly onto your lashline.
Step 4: Seal Your Lashes
Once all the segments are on, apply coats of sealant to the applicator and seal your lashes together with a pressing motion. You can repeat this up to 3 times.
How to use our 2-System Bond
Applying the right amount will result in salon-quality lashes, 100% waterproof & will hold up for 2 weeks.
Tip #1 Apply bond to segments
Make sure to apply bond to all segments before applying to your lashes. Without the bond on the segments, they will not stick as easy.
Tip #2 Don’t over apply
Too much bond can cause natural lashes to look clumpy and create an undesired look
Tip #3 Hold your applicator vertically
When applying your segments hold you applicator vertically. Applying each segment in a upward scooping motion.
Tip #4 Apply sealant 3 times
Not enough coats may cause your segments to fall when showering or sleeping.
Tip #5 Clean your applicator
Make sure to clean your applicator throughout your application.
Don't get your lashes wet for 24 hours
Don't pick at, pull, or peel your lashes
Don't sleep on your face
Don't use oil based makeup
Don't touch your lashes when they are wet
Avoid direct water pressure on your face while showering
Don't use mascara
Our Removal Step by Step
Step 1: Apply Serum
Apply Purify Lash Serum to a eyelash cotton swab.
Step 2: Coat Lashes
Apply serum to the roots of your lashes. Wait for 1 - 2 minutes to absorb.
Step 3: Peel Gently
Gently peel off the segments from the edges of the band with your applicator.
Step 4: Wash Face
Wash your lashes with face wash and you are ready for the next set.
Top Tip & Tricks For the Best Results
How to Prep
How to have your lashes ready for application.
How to Apply
Step by step on how to apply using the Gridlock Method.
Easy & Quick way to apply your lash extensions.
Quick way to seal your natural lashes with lash extensions.
Do's & Don'tsDIY Lash Extensions
Tip #1 For Beginners
Step by Step, How to apply for beginners
Tip #2 New Technology
How the 2-System Bond works with our lashes.
Tip #3 Clean Lashes
Clean Lash residue glue off lash segments.
Tip #4 Applying Bond
Do’s & Dont’s - Bond Edition.
Tip #5 Sticky Applicator
How to clean your sticky applicator from bond.
Tip #6 Applying Sealant
3 ways on how to apply sealant for longer lasting lashes.
Tip #7 Having Trouble Applying?
Still having trouble applying? Schedule a 1 on 1 with a lash expert.
Tip #8 Lash Maintenance
Do’s & Dont’s with Lash Maintenance.
Still need some help? Check out our
Help Center, where you can ask a specific
question and get the help you need.
Connect with other, ask questions, get some
tips and tricks on our Facebook Group.